• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery. When replacing the electrical parts provided with memory functions that store contents specified by a customer, record the memory contents before disconnecting the battery ground cable. • Be careful of the following items. Failing to do so may cause the airbag system malfunction. – Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuits, follow the cautions of “AIRBAG SYSTEM”. General Description > CAUTION – Be careful not to damage the airbag system wiring harness when servicing the electrical parts around the steering column. • When removing, installing or replacing the VDCCM&H/U, VDCCM&H/U bracket, steering wheel or steering angle sensor (steering roll connector), perform “VDC sensor midpoint setting mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT • Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb. • Always replace with a bulb that is the same model and wattage as those of the old one. |
Removal
1. TIMING CHAIN RHNOTE:When replacing a single part, perform the work with the engine assembly installed to body.1. Remove the chain cover. Chain Cover > REMOVAL2. Using ST and by turning the crankshaft, align the alignment marks of crank sprocket, intake cam sprocket RH and exhaust cam sprocket RH ...