Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Caution

Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery. When replacing the electrical parts provided with memory functions that store contents specified by a customer, record the memory contents before disconnecting the battery ground cable.

If any immobilizer related part has been replaced, make sure to register the immobilizer.

Be careful of the following items. Failing to do so may cause the airbag system malfunction.

Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuits, follow the cautions of “AIRBAG SYSTEM”. General Description > CAUTION

Be careful not to damage the airbag system wiring harness when servicing the electrical parts around the steering column.

When removing, installing or replacing the VDCCM&H/U, VDCCM&H/U bracket, steering wheel or steering angle sensor (steering roll connector), perform “VDC sensor midpoint setting mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT

Preparation tool
1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — (Newly adopted tool)SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed op ...

Component
1. DOOR LOCK ASSEMBLY(A)Front(B)Rear (1)Grommet - screw(9)Key lock - door (driver’s seat only)(17)Frame ASSY - rear door outer(2)Remote ASSY - door(10)Spacer - door handle outer B (3)Cap r ...

Other materials:

Installation
1. Before installation, check the universal joint assembly - steering. Universal Joint > INSPECTION2. Adjust the tilt position of the steering column to the neutral position.CAUTION:Always place the tilt lever to the lock position after the steering column is adjusted.3. Unfasten the seat belt and ...

© 2017-2024 Copyright www.sulegacy.com