Subaru Legacy BN/BS (2015-2019) Service Manual: Caution
• Prior to starting work, pay special attention to the following: 1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary. 2. Protect the vehicle using a seat cover, fender cover, etc. 3. Prepare the service tools, clean cloth, containers to catch grease and oil, etc. • Vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts. • When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement. • Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery. • Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle. • Remove contamination including dirt and corrosion before removal, installation, disassembly or assembly. • Keep the removed parts in order and protect them from dust and dirt. • All removed parts, if to be reused, should be reinstalled in the original positions with attention to the correct directions, etc. • Bolts, nuts and washers should be replaced with new parts as required. • Be sure to tighten the fasteners including bolts and nuts to the specified torque. |
Specification
Accelerator pedalStrokeAt pedal pad50 — 59 mm (1.97 — 2.32 in) ...
Preparation tool
1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS18460AA050CHECK BOARDUsed for inspecting the accelerator pedal. — (Newly adopted tool)SUBARU SELECT MONITOR 4Used for setting of each function ...
Other materials:
Road test inspection
1. GENERAL PRECAUTIONRoad tests should be conducted to properly diagnose the condition of CVT.CAUTION:Always observe the local traffic laws when performing the test.2. D RANGE SHIFT FUNCTIONMake sure that the engine speed is 1,100 — 1,400 r/min while driving on the level road at 50 km/h (31 MPH) a ...
