Subaru Legacy BN/BS (2015-2019) Service Manual: Caution

Subaru Legacy BN/BS (2015-2019) Service Manual / Intake (induction)(h4do) / General description / Caution

• Prior to starting work, pay special attention to the following:

1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.

2. Protect the vehicle using a seat cover, fender cover, etc.

3. Prepare the service tools, clean cloth, containers to catch grease and oil, etc.

• Vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.

• When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.

• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery.

• Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.

• Remove contamination including dirt and corrosion before removal, installation, disassembly or assembly.

• Keep the removed parts in order and protect them from dust and dirt.

• All removed parts, if to be reused, should be reinstalled in the original positions with attention to the correct directions, etc.

• Bolts, nuts and washers should be replaced with new parts as required.

• Be sure to tighten the fasteners including bolts and nuts to the specified torque.

Component

(1)Air intake duct(10)Spacer(19)Clamp(2)Clip(11)Cushion (3)Cushion(12)Air cleaner elementTightening torque: N·m (kgf-m, ft-lb)(4)Resonator chamber(13)Air cleaner case (rear)T1:1 (0.1, 0.7)(5)C ...

Other materials:

Rear window wiper blade rubber (Outback)
Pull out the end of the blade rubber assembly to unlock it from the plastic support. Pull the blade rubber assembly out of the plastic support. 1) Metal spines If the new blade rubber is not provided with two metal spines, remove the metal spines from the ...