Subaru Legacy BN/BS (2015-2019) Service Manual: Check list for interview check

Subaru Legacy BN/BS (2015-2019) Service Manual / Lan system (diagnostics) / Check list for interview check

Inspect the following items regarding the vehicle’s state.

1. DISPLAY STATUS IN THE COMBINATION METER

Display status in the combination meter	Engine coolant temperature gauge display	OK / NG
	Fuel gauge display	OK / NG
	Tachometer display	OK / NG (0 rpm at idling etc.)
Display of other indicators	Malfunction indicator light	ON / Blink / OFF
	SPORT indicator light (AT warning light)	ON / Blink / OFF
	ABS warning light	ON / Blink / OFF
	VDC warning light	ON / Blink / OFF
	Immobilizer indicator light	ON / Blink / OFF
	AT OIL TEMP warning light	ON / Blink / OFF
	Tire pressure warning light	ON / Blink / OFF
	Engine coolant temperature warning light	Blue light ON / Red light ON / Red light blinks / Blue and red lights blink
	CRUISE indicator	ON / Blink / OFF
	Shift indicator	OK / NG
	Fuel level warning light	ON / Blink / OFF
	Airbag warning light	ON / OFF
	VDC OFF indicator	ON / OFF
	Brake warning light	ON / OFF
	EyeSight warning light	ON / Blink / OFF
	Lane departure warning OFF indicator light	ON / OFF
	Pre-collision brake OFF indicator light	ON / OFF
	Headlight beam leveler indicator	ON / OFF

2. CONDITIONS UNDER WHICH TROUBLE OCCURS

Driving condition	At standstill (while idling)
	When the vehicle is running	Vehicle speed km/h (MPH)
	While accelerating	Acceleration km/h (MPH) to km/h (MPH)
	Decelerating (with braking)	Deceleration km/h (MPH) to km/h (MPH)
	Decelerating (without braking)	Deceleration km/h (MPH) to km/h (MPH)
	Flat road Uphill Downhill Gravel road Bumpy road Snowy road
	Does it occur when operating any part- Operated part: TROUBLE SYMPTOM:
	Are there any other troubles occurred- From where: TROUBLE SYMPTOM:

Can bus ecu communication check operation

Systems connected to vehicle CAN bus and require communicating with the Subaru Select Monitor will be displayed.List of the systems displayed does not mean the confirmation of communication. It displa ...

Clear memory mode operation

1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «All diagnosis cod ...

Other materials:

Dtc b2a06 right speaker/audio circuit
DIAGNOSIS START CONDITION:When ACC is ON.DTC DETECTING CONDITION:Speaker impedance is more than 10 k- for 100 mS. (Detached speaker connection, etc.)TROUBLE SYMPTOM:• Call function cannot be used.• RED LED illuminates.WIRING DIAGRAM:NOTE:For the coupling connector, refer to “WIRING ...