Subaru Legacy BN/BS (2015-2019) Service Manual: Clear memory mode operation
1. SUBARU SELECT MONITOR 1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «Engine Control System» and then «Enter». 5. On «Select Function» display, select «DTC». 6. On «DTC» display, select «Clear Memory». NOTE: • Initial diagnosis of electronic throttle control is performed after memory clearance. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine. • For detailed operation procedures, refer to “Application help”. 2. GENERAL SCAN TOOL For clear memory procedures using the general scan tool, refer to “General Scan Tool Instruction Manual”. NOTE: Initial diagnosis of electronic throttle control is performed after memory clearance. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine. |
Check list for interview check
1. CHECK LIST NO. 1Check the following item when problem has occurred.NOTE:Use copies of this page for interviewing customers.Customer’s name Engine No. Date of purchase Fuel type Date of repair ...
Data link connector note
This connector is used for Subaru Select Monitor.CAUTION:Do not connect any scan tools other than Subaru Select Monitor or general scan tool because the circuit for Subaru Select Monitor may be damage ...
Other materials:
General scan tool operation
1. HOW TO USE GENERAL SCAN TOOL1. Prepare a scan tool (general scan tool) required by SAE J1978.2. Connect the general scan tool to data link connector located in the lower portion of the instrument panel (on the driver’s side).3. Using the general scan tool, call up each data. General scan to ...
