NOTE: For detailed operation procedures, refer to “Application help”. 1. ECM 1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «Engine Control System» and then select «Enter». 5. On «Engine Control System» display, select «DTC». 6. On «DTC» display, select «Clear Memory». NOTE: Initial diagnosis of electronic throttle control is performed after memory clearance. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine. 2. BODY INTEGRATED UNIT NOTE: Except for C0 and C5 models 1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «Body Control» and then select «Enter». 5. On «Body Control» display, select «DTC». 6. On «DTC» display, select «Clear Memory». 3. IMMOBILIZER CM NOTE: For C0 and C5 models 1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «Immobilizer» and then select «Enter». 5. On «Immobilizer» display, select «DTC». 6. On «DTC» display, select «Clear Memory». |
Installation
1. Install the purge control solenoid valve, and connect the connector and vacuum hose to the purge control solenoid valve.NOTE:Connect the vacuum hose as shown in the figure.(a)To intake manifold(b)To fuel pipe Tightening torque:19 N·m (1.9 kgf-m, 14.0 ft-lb)2. Install the air intake boot. ...