Subaru Legacy BN/BS (2015-2019) Service Manual: Clear memory mode operation
1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «Keyless Access with Push Button Start» and then select «Enter». 5. On «Select Function» display, select «DTC». 6. On «DTC» display, select «Clear Memory». NOTE: • For detailed operation procedures, refer to “Application help”. • Initial diagnosis of electronic throttle control is performed after memory clearance. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine. |
Check list for interview check
Inspect the following items regarding the vehicle’s state.Keyless Access with Push Button Start System Trouble Check List for Interview Received Year Month DateCustomer&rsquo ...
Electrical component location location
(1)Keyless access CM(8)ECM(14)Center interior antenna(2)Mechanical key(9)Front interior antenna(15)Rear interior antenna(3)Access key(10)TCM (engine type: FB)(16)Rear exterior antenna(4)ID code box(Fo ...
Other materials:
Inspection mode procedure
It is possible to diagnose the DTC by performing the indicated inspection mode. After correcting the DTC, perform a necessary inspection mode and make sure that the function is resumed correctly and the DTC is recorded.1. INSPECTION MODE 1DTCItemNoteB2600LIN COMMUNICATION — B2601LIN CIRCUIT LOW †...
