After repairing the occupant detection system, clear the DTCs stored in the airbag control module and the occupant detection control module. 1. AIRBAG SYSTEM 1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «Airbag» and select «Enter». 5. On «Airbag» display, select «DTC». 6. On «DTC» display, select «Clear Memory». NOTE: For detailed operation procedures, refer to “Application help”. 2. OCCUPANT DETECTION SYSTEM 1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «Occupant Detection» and then select «Enter». 5. On «Occupant Detection» display, select «DTC». 6. On «DTC» display, select «Clear Memory». NOTE: For detailed operation procedures, refer to “Application help”. |
Dtc p2103 throttle actuator "a" control motor circuit high
DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE TYPE FB (WITHOUT PUSH BUTTON ST ...