Subaru Legacy BN/BS (2015-2019) Service Manual: Clear memory mode operation

Subaru Legacy BN/BS (2015-2019) Service Manual / Tire pressure monitoring system (diagnostics) / Clear memory mode operation

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Tire Pressure Monitor» and then select «Enter».

5. On «Select Function» display, select «DTC».

6. On «DTC» display, select «Clear Memory».

NOTE:

For detailed operation procedures, refer to “Application help”.

Basic diagnostic procedure procedure

CAUTION:Remove foreign matter (dust, water, oil, etc.) from the TPMS & keyless entry CM connector or TPMS CM connector during removal and installation.NOTE:To check harness for open or short circuits, ...

Electrical component location location

(1)Tire pressure warning light(2)TPMS & keyless entry CM*1 or TPMS CM*2(3)Snap-in type transmitter*1: Without push button start*2: With push button start ...

Other materials:

Component
1. PROPELLER SHAFT(1)Propeller shaft(3)Rear differential (T-type)Tightening torque: N·m (kgf-m, ft-lb)(2)Rear differential (VA1-type)(4)Rear differential (VA2-type)T1:31 (3.2, 22.9) T2:52 (5.3, 38.4)2. FRONT AXLE(1)Circlip(8)Boot (PTJ)(15)Axle nut(2)Baffle plate(9)O-ring (3)Outer race (PTJ ...