Subaru Legacy BN/BS (2015-2019) Service Manual: Crankshaft position sensor plate

Installation

1. Install the crankshaft position sensor to the cylinder block, and connect the connector to the crankshaft position sensor.Tightening torque:6.4 N·m (0.7 kgf-m, 4.7 ft-lb)2. Install the air i ...

Removal

The crankshaft position sensor plate is tightened together with the drive plate or flywheel; therefore, refer to “Drive Plate” or “Flywheel” for removal procedure. Drive Plate ...

Other materials:

Removal
NOTE:Do not remove the room light if removing the bulb only.1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the light assembly - room.(1) Remove the clips, and then remove the hook.(2) Disconnect the connector and remove the light assembly - room.3. Release the claws, and detac ...