Subaru Legacy BN/BS (2015-2019) Service Manual: Data link connector note
This connector is used for Subaru Select Monitor. CAUTION: Do not connect any scan tools other than Subaru Select Monitor or general scan tool because the circuit for Subaru Select Monitor may be damaged. Terminal No. | Contents | Terminal No. | Contents | 1 | Blank | 9 | Blank | 2 | Blank | 10 | Blank | 3 | Blank | 11 | Blank | 4 | Ground | 12 | Blank | 5 | Ground | 13 | Blank | 6 | CAN communication (Hi) | 14 | CAN communication (Lo) | 7 | Blank | 15 | Blank | 8 | Blank | 16 | Power supply |
|
1. SUBARU SELECT MONITOR1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, se ...
1. CONTROL MODULE(1)Engine control module (ECM)(3)Malfunction indicator light(4)Delivery (test) mode fuse(2)Data link connector 2. SENSOR(1)Tumble generator valve actuators (with built-in opening a ...
Other materials:
Installation
CAUTION:Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occurs, replace with a new part.1. Connect the harness connector.2. Install the primary speed sensor.NOTE:• Use new O-rings.• Apply CVTF to the O-rings.Tightening torque:7 ...