CAUTION: Be careful not to allow foreign matter to enter the brake hose connector. 1. Remove mud and foreign matter from the caliper body assembly. 2. Remove the piston - disc brake. (1) Place a wooden block in the caliper body as shown in the figure to prevent the piston - disc brake from jumping out and being damaged. (2) Using an air gun, gradually apply compressed air via the brake hose installation hole to push out the piston - disc brake. NOTE: Instead of removing the pistons one by one, remove all pistons at once after adjusting the amount of protrusion evenly using a wooden block. 3. Remove the piston boot (b) and piston seal (c) from the caliper body cylinder (a). CAUTION: Do not damage the cylinder and piston seal groove. 4. Remove each part from support - front disc brake.
|
Dtc b2a01 lte1 antenna circuit
DIAGNOSIS START CONDITION:When ignition switch is ON.DTC DETECTING CONDITION:Any of the followings continues for 5 seconds or more.• LTE1 impedance is more than 1 M-. (Detached antenna, etc.)• LTE1 impedance is less than 1 k-. (Short-circuited antenna, etc.)TROUBLE SYMPTOM:• Telema ...