Subaru Legacy BN/BS (2015-2019) Service Manual: Disassembly
1. Flatten the tab of the lock nut. 2. Using ST1, ST2 and ST3, fix at the spline portion of drive pinion shaft to remove the lock nut.
3. Remove the drive pinion shaft from the drive pinion retainer.
4. Using the round bar with diameter of 36 mm (1.42 in) or 37 mm (1.46 in), remove the bearing inner race and plug.
5. Remove the drive pinion washer. 6. Remove the drive pinion spacer.
7. Remove the O-rings.
8. Remove the inner race and drive pinion shim from drive pinion shaft using ST.
9. Using the ST, remove the outer race.
10. Remove the two oil seals using a screwdriver wrapped with cloth, etc. CAUTION: Do not damage the fitting surface of oil seal.
11. Remove the plug from drive pinion retainer.
|
Inspection
• Make sure that all component parts are free of scratches, holes and other faults.• Check the tooth contact. Drive Pinion Shaft Assembly > ADJUSTMENT• Apply CVTF to bearing and rot ...
Assembly
1. Install the plug to drive pinion retainer.NOTE:• Use new O-rings.• Apply CVTF to the O-rings.Tightening torque:22 N·m (2.2 kgf-m, 16.2 ft-lb)2. Using the ST, install the oil seal ...
Other materials:
Dtc c1424 ecm
DTC DETECTING CONDITION:A fault is detected if malfunction judgment flag for the engine system is received from ECM for a predetermined time or more.TROUBLE SYMPTOM:• Hill hold does not function.• EyeSight does not operate. (Models with EyeSight)STEPCHECKYESNO1.CHECK ECM.1) Start the eng ...
