1. DIFFERENTIAL CASE ASSEMBLY 1. Remove the taper roller bearing using the ST.
2. Remove the hypoid driven gear mounting bolt using the ST.
3. Remove the differential case (LH). 4. Remove the differential bevel gear and washer. 5. Remove the straight pin. 6. Remove the pinion shaft, then remove the differential bevel gear, washer and differential bevel pinion.
2. SIDE RETAINER NOTE: After adjusting the drive pinion backlash and tooth contact, replace the oil seal and O-ring with new parts. 1. Remove the O-rings. 2. Remove the oil seal. |
Warning and indicator lights
Several of the warning and indicator lights
illuminate momentarily and then go out
when the ignition switch is initially turned
to the "ON" position. This permits checking
the operation of the bulbs.
Apply the parking brake and turn the
ignition switch to the "ON" position. For
the system c ...