1. Remove the snap ring, and then remove the retaining plate, drive plate and driven plate.
2. Compress the return spring using the ST to remove the snap ring.
3. Remove the transfer clutch piston seal. 4. Remove the return spring. 5. Remove the transfer clutch piston by blowing compressed air through transfer clutch assembly hole. NOTE: Plug the holes through which the compressed air is not blown. 6. Remove the ball bearing using ST.
|
Basic diagnostic procedure procedure
STEPCHECKYESNO1.CHECK WARNING LIGHT.Check whether the airbag warning light in the combination meter is lit.Does the airbag warning light illuminate- Basic Diagnostic Procedure > PROCEDUREPerform the diagnosis according to phenomenon of the problem.2.READ DTC.1) Turn the ignition switch to OFF.2) Con ...