1. Remove the front reduction driven shaft from the front reduction driven gear. 2. Remove the snap ring. 3. Remove the retaining plate, drive plate, driven plate and dish plate. 4. Remove the seal ring from front reduction driven shaft. 5. Remove the ball bearing, while tapping the entire circumference around the ball bearing outer race a little at a time through the front reduction driven shaft hole using the round bar with diameter of 7 mm (0.28 in). |
Weather strip replacement
1. FLANGE1. Remove the weather strip - body side flange while pulling the rubber. Be careful not to tear the rubber.2. Replace the weather strip - trunk lid while pulling the rubber. Be careful not to tear the rubber.NOTE:While removing the weather strip - trunk lid, be careful not to allow adhesive ...