1. Remove the snap ring, and then remove the retaining plate, drive plate and driven plate.
2. Using the ST, remove the snap ring.
3. Remove the transfer clutch piston seal. 4. Remove the return spring. 5. Remove the transfer clutch piston by blowing compressed air through transfer clutch assembly hole. NOTE: Block the hole opposite to the one to be blown with compressed air by your finger. 6. Using ST, remove transfer drive gear, parking gear and ball bearing.
NOTE: Let the ST sit on the parking gear. 7. Remove the snap ring from transfer reduction drive gear. 8. Using the ST, remove the parking gear from transfer reduction drive gear.
|
Caution
1. BSD/RCTA(1) In some cases, BSD/RCTA may not work correctly under the following conditions.• In bad weather such as heavy rain, fog, snow, sand storm, etc.• When ice, snow, dirt, etc. cover the rear bumper.• When the rear bumper has scratches or deformation in the area of the rad ...