Subaru Legacy BN/BS (2015-2019) Service Manual: Disassembly
1. Place alignment marks on the shaft and outer race.
2. Remove the PTJ boot band and boot. CAUTION: Be careful not to damage the boot.
3. Remove the snap ring from PTJ outer race.
4. Remove the PTJ outer race from shaft assembly. 5. Wipe off grease. CAUTION: The grease is a special type of grease. Do not mix with other grease. 6. Place alignment marks on the roller kit and trunnion.
7. Remove the roller kit from trunnion. CAUTION: Be careful with the roller kit position. 8. Place alignment marks on the trunnion and shaft.
9. Remove the snap ring and trunnion. CAUTION: Be sure to wrap shaft splines with vinyl tape to protect the boot from scratches.
10. Remove the PTJ boot. 11. Remove the O-ring from the groove of the shaft. NOTE: The EBJ is a non-disassembly part, so the axle disassembly stops here. |
Inspection
Check the removed parts for damage, wear, corrosion etc. If faulty, repair or replace.• PTJ (pillow tripod joint)Check for seizure, corrosion, damage, wear and excessive play.• EBJ (high-e ...
Other materials:
Removal
CAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. N ...
