Subaru Legacy BN/BS (2015-2019) Service Manual: Disassembly

Subaru Legacy BN/BS (2015-2019) Service Manual / Drive shaft system / Rear axle / Disassembly

1. BUSHING - REAR AXLE HOUSING

Do not remove the housing assembly - rear axle because the bushing - rear axle housing cannot be replaced. If it is removed, replace the housing assembly - rear axle.

2. BUSHING - TRAILING LINK

1. Remove the housing assembly - rear axle. Rear Axle > REMOVAL

2. Using the ST and a hydraulic press, push out the bushing.

Preparation tool:

ST1: BUSHING REMOVER (20099FG000)

ST2: INSTALLER & REMOVER (BASE) (20099PA010)

(1)

Housing ASSY - rear axle

(2)

Bushing - trailing link

Installation

1. Temporarily tighten the housing assembly - rear axle to the upper arm assembly.2. Install the rear drive shaft assembly. Rear Drive Shaft > INSTALLATIONCAUTION:Do not hammer the drive shaft assemb ...

Rear drive shaft

...

Other materials:

Inspection
1. PURGE CONTROL SOLENOID VALVE1. Check that the purge control solenoid valve has no deformation, cracks or other damages.2. Measure the resistance between the purge control solenoid valve terminals.Terminal No.Standard1 and 224.5±1.5 - (20°C (68°F))3. Check that air does not come out ...