Subaru Legacy BN/BS (2015-2019) Service Manual: Disassembly

Subaru Legacy BN/BS (2015-2019) Service Manual / Drive shaft system / Rear hub unit bearing / Disassembly

Using the ST or a hydraulic press, push out the bolt - hub (b) from the hub unit COMPL - rear axle (a).

CAUTION:

• Be careful not to hammer the bolts - hub. This may deform the hub unit COMPL.

• Do not reuse the bolt - hub.

NOTE:

Since the hub unit COMPL - rear axle cannot be disassembled, only bolts - hub can be removed.

Preparation tool:

ST: HUB STAND (28399AG000)

Inspection

1. Moving the rear tire up and down by hand, check there is no backlash in bearing, and check the wheel rotates smoothly.CAUTION:If there is any fault in the bearing, replace the hub unit COMPL - rear ...

Engine (diagnostics)(h4do)

...

Other materials:

Dtc p2402 evap system leak detection pump control circuit high
DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE TYPE FB (WITHOUT PUSH BUTTON ST ...