1. BUSHING FRONT - FRONT ARM 1. Put an alignment mark on the front arm assembly based on the split portion of the bushing intermediate plate of the busing front - front arm. CAUTION: Always put an alignment mark for aligning the position on bushing installation.
2. Using the ST and a press, remove the front bushing. Preparation tool: ST: INSTALLER & REMOVER SET (927680000) 2. BUSHING REAR - FRONT ARM 1. Remove the rear bushing assembly. (1) Put alignment marks on the front arm assembly and the bushing rear - front arm. • Front arm assembly replacement: put an alignment mark (a) from the cutout portion of the front arm assembly to the bushing rear - front arm. • Bushing rear - front arm replacement: put an alignment mark (b) on the front arm assembly located on an imaginary line extending from the rib portion of the bushing rear - front arm. (2) Remove the self-locking nut, and then remove the rear bushing assembly. |
Component
1. PARKING BRAKE ACTUATOR(1)Support - rear disc brake(8)Pin bootTightening torque: N·m (kgf-m, ft-lb)(2)Guide pin - rear brake(9)Piston bootT1:8 (0.8, 5.9)(3)Parking brake actuator ASSY(10)Caliper bodyT2:17 (1.7, 12.5)(4)O-ring(11)Pad - disc brake rear innerT3:25 (2.5, 18.4)(5)Cap(12)Pad - di ...