1. DIFFERENTIAL CASE ASSEMBLY 1. Loosen the twelve bolts and remove hypoid driven gear.
2. Drive out the straight pin from differential assembly toward hypoid driven gear side.
3. Pull out the pinion shaft, and remove the differential bevel pinion, differential bevel gear and adjusting washer.
4. Using the ST, remove the taper roller bearing.
2. DIFFERENTIAL SIDE RETAINER 1. Remove the O-rings. 2. Remove the oil seal. NOTE: Remove using the flat tip screwdriver. |
Inspection
CAUTION:Check and adjust the V-belt tension so that it is within the specified range. Using the belt with a tension out of the specified range may result in a fault such as the following:• If the V-belt tension is higher, unexpected force is generated at the power steering oil pump, generator ...