Subaru Legacy BN/BS (2015-2019) Service Manual: Disassembly
CAUTION: When fixing the steering gearbox assembly in a vise, apply a wooden piece on the flange portion. 1. Remove the tie-rod end (a) and lock nut (b) from the steering gearbox assembly. 2. Remove the clip - boot tie-rod (c) located outside the boot - steering gearbox using the pliers, and then slide the boot - steering gearbox to the tie-rod end side.
3. Remove the tie-rod (d) from the gearbox assembly. (1) Using a flat tip screwdriver, remove the band - boot (e) from the boot - steering gearbox. NOTE: Replace the boot - steering gearbox or the band - boot (e) if there is damage, cracks or deterioration. (2) Remove the tie-rod (d).
|
Inspection
1. UNIT INSPECTIONCheck components for wear, damage or other faults. Adjust or replace if necessary.2. LIMITMake a measurements as follows. If it exceeds the specified service limits, adjust or replac ...
Assembly
1. Install the tie-rod into rack.Tightening torque:90 N·m (9.2 kgf-m, 66.4 ft-lb)NOTE:Check the mating face of rack and tie-rod for foreign matter such as dust etc.2. Apply a coat of grease to ...
Other materials:
Changing the oil and oil filter
Change the oil and oil filter according to
the maintenance schedule in the "Warranty
and Maintenance Booklet".
NOTE
Changing the engine oil and oil filter
should be performed by a well-trained
expert. Contact your SUBARU dealer
for changing the engine oil and oil filter.
Fully t ...
