CAUTION: • When removing the mirror - repair, be careful not to damage the back surface of mirror - repair with a flat tip screwdriver. • When removing the mirror - repair, insert the connector and clip securely. 1. Operate the remote control mirror switch to face the mirror - repair upward. 2. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE 3. Remove the mirror - repair. (1) Using a flat tip screwdriver or similar tool, release the engagement shown in the figure, and slide the mirror - repair downward to remove. (2) Disconnect connectors. (Model with mirror heater and Subaru Rear Vehicle Detection system) 4. Release the claws, and then remove the cover - cap outer mirror lower. 5. Release the claws, and then remove the cover - cap outer mirror. CAUTION: Be careful not to apply excessive force when removing the cover - cap outer mirror, as the lower hooks may become damaged. 6. Remove the light assembly - side turn mirror. (Model with side turn signal light) (1) Remove the screws and pull out the light assembly - side turn mirror to the front of the vehicle. (2) Disconnect the connector and remove the light assembly - side turn mirror. |
Component
(1)TPMS & keyless entry control module (model without keyless access with push button start system)(4)Transmitter (snap in type)Tightening torque: N·m (kgf-m, ft-lb)(2)TPMS CM (model with keyless access with push button start system)(5)ValveT1:1.4 (0.1, 1.0)(3)Screw T2:7.5 (0.8, 5.5)(1)TPMS ...