Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc b1407 met communication

Subaru Legacy BN/BS (2015-2019) Service Manual / Immobilizer (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc b1407 met communication

DIAGNOSIS START CONDITION:

• Battery voltage is 10 V or more.

• The remote engine starter was not used to start the engine.

DTC DETECTING CONDITION:

Communication failure between body integrated unit and combination meter

TROUBLE SYMPTOM:

• Engine will not start.

• The security indicator illuminates.

CAUTION:

When the combination meter is replaced, registration of the immobilizer system is required. For details, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.

STEP	CHECK	YES	NO
1.CHECK DTC. Read the DTC of the body integrated unit. Read Diagnostic Trouble Code (DTC)	Is DTC of the body integrated unit except for DTC B1407 displayed-	Perform the diagnosis according to the DTC.	Check the combination meter. Basic Diagnostic Procedure > PROCEDURE

Dtc b1408 meter non-volatile memory

DIAGNOSIS START CONDITION:• Battery voltage is 10 V or more.• The remote engine starter was not used to start the engine.DTC DETECTING CONDITION:Defective combination meterTROUBLE SYMPTOM: ...

Dtc b1402 immobilizer key collation

NOTE:Refer to DTC B1575 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1575 INCORRECT IMMOBILIZER KEY ...

Other materials:

Engine oil pressure inspection
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the oil pressure switch. Oil Pressure Switch > REMOVAL3. Install the oil pressure gauge to the installation area for the oil pressure switch of the chain cover.4. Connect the ground terminal to battery sensor. NOTE5. Start the e ...