1.CHECK CONNECTOR. 1) Check connecting condition of the A/C CM connector and air mix door actuator LH connector. 2) Read the DTC using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC) | | Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1442 AIR MIX DOOR ACTUATOR CIRCUIT SHORT-CIRCUIT (DRIVER) | Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again. NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause. |
2.CHECK AIR MIX DOOR ACTUATOR LH. 1) Disconnect the air mix door actuator LH. 2) Read the DTC using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC) | | Replace the air mix door actuator LH. Air Mix Door Actuator > REMOVAL | Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1442 AIR MIX DOOR ACTUATOR CIRCUIT SHORT-CIRCUIT (DRIVER) |
3.CHECK HARNESS (SHORTED BETWEEN LINES AND SHORTED TO GROUND). 1) Disconnect the connector from A/C CM. 2) Using a tester, check continuity between terminals. Connector & terminal (i174) No. 3 — (i174) No. 5: (i174) No. 5 — Chassis ground: | | Repair or replace the short circuit of the harness. | Replace the A/C CM. Control Unit > REMOVAL |