Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc b1693 door sensor rh initialization incomplete

DIAGNOSIS START CONDITION:

Ignition voltage is 10 V to 16 V.

DTC DETECTING CONDITION:

Front door impact sensor RH unit malfunction (sensor type abnormal, sensor unit initialization error)

CAUTION:

Before performing diagnosis, refer to “CAUTION” in “General Description”. General Description > CAUTION

WIRING DIAGRAM:

NOTE:

For the coupling connector, refer to “WIRING SYSTEM”.

Airbag system Airbag System > WIRING DIAGRAM

STEPCHECKYESNO

1.CHECK POOR CONTACT OF CONNECTORS.

Check for poor contact of the connectors between the airbag control module and the front door impact sensor RH.

Is there poor contact-

Replace the airbag rear harness and the door harness.

Diagnostic Chart with Trouble Code > DTC B1693 DOOR SENSOR RH INITIALIZATION INCOMPLETE

2.CHECK FRONT DOOR IMPACT SENSOR RH.

1) Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 60 seconds or more.

2) Disconnect the connector (AB64) from front door impact sensor RH. Front Door Impact Sensor > REMOVAL

3) Temporarily connect a new front door impact sensor to the connector (AB64).

4) Connect all connectors.

5) Clear the memory. Clear Memory Mode

6) Perform the Inspection Mode. Inspection Mode

7) Read the DTC. (Current malfunction) Read Diagnostic Trouble Code (DTC)

Is DTC B1693 displayed-

Diagnostic Chart with Trouble Code > DTC B1693 DOOR SENSOR RH INITIALIZATION INCOMPLETE

Replace the front door impact sensor RH. Front Door Impact Sensor > REMOVAL

3.CHECK AIRBAG CONTROL MODULE.

1) Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 60 seconds or more.

2) Restore the front door impact sensor RH back to the original position. Front Door Impact Sensor > REMOVAL

3) Connect all connectors.

4) Clear the memory. Clear Memory Mode

5) Perform the Inspection Mode. Inspection Mode

6) Read the DTC. (Current malfunction) Read Diagnostic Trouble Code (DTC)

Is DTC B1693 displayed-

Replace the airbag control module. Airbag Control Module > REMOVAL

Diagnostic Chart with Trouble Code > DTC B1693 DOOR SENSOR RH INITIALIZATION INCOMPLETE

4.CHECK FOR ANY OTHER DTC ON DISPLAY.

Read the DTC. (Current malfunction) Read Diagnostic Trouble Code (DTC)

Is any other DTC displayed-

Check DTC using “List of Diagnostic Trouble Code”. List of Diagnostic Trouble Code (DTC) > LIST

Finish the diagnosis.

Dtc b1695 door sensor lh failure
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Front door impact sensor RH unit internal malfunctionIf DTC AB is displayed, the circuit within the front door impact ...

Dtc b1692 lost communication with door sensor rh
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Front door impact sensor RH communication error (open/short circuit or connector connection failure between airbag CM ...

Other materials:

Inspection
Check the following items.• Check the oil pump for damage and wear.• Rotate the oil pump by hand, and check that it rotates smoothly.1. Measure the secondary pressure. Secondary Pressure (Line Pressure) Test > INSPECTION2. Remove the oil pan and oil strainer. Control Valve Body > REMOV ...

© 2017-2024 Copyright www.sulegacy.com