Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc b2900 ahl control

Subaru Legacy BN/BS (2015-2019) Service Manual / Steering responsive fog lights (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc b2900 ahl control

DTC DETECTING CONDITION:

Detected when internal malfunction occurs in SRF CM.

TROUBLE SYMPTOM:

The auto headlight beam leveler does not operate.

CAUTION:

Initialization is required after replacing the SRF CM.

(Initialization is not required for models without auto headlight beam leveler system)

STEP	CHECK	YES	NO
1.CHECK DTC. 1) Turn the ignition switch to OFF > ON. 2) Turn on the headlight low beam. 3) Using the Subaru Select Monitor, clear the auto headlight beam leveler system memory. Clear Memory Mode 4) Use the Subaru Select Monitor and read DTCs. Read Diagnostic Trouble Code (DTC)	Is DTC B2900 displayed- (current malfunction)	Replace the SRF CM. Steering Responsive Fog Lights CM	Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again. NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

Dtc b2902 rear height sensor circuit

DTC DETECTING CONDITION:Rear vehicle height sensor error is detected for 10 seconds or more.TROUBLE SYMPTOM:The auto headlight beam leveler does not operate.CAUTION:Initialization is required after re ...

Dtc u0122 lost communication with vehicle dynamics control module

Detected when CAN data (vehicle speed signal) is not received from VDC CM.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE ...

Other materials:

Inspection
1. CLUTCH START SWITCH1. Perform the following inspections. If the clutch start switch does not operate normally, adjust the switch, and check it again. Clutch Switch > ADJUSTMENT• Make sure that engine does not start with clutch pedal not depressed.• Make sure that engine starts with c ...