DTC DETECTING CONDITION: Detected when two consecutive driving cycles with fault occur. TROUBLE SYMPTOM: • Engine stalls. • Failure of engine to start CAUTION: After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.
1. OUTLINE OF DIAGNOSIS Detect for faults in crankshaft position sensor output properties. Judge as NG when there is a problem in the number of crankshaft signals for every revolution of crankshaft. 2. COMPONENT DESCRIPTION
3. EXECUTION CONDITION
4. GENERAL DRIVING CYCLE Always perform the diagnosis continuously. 5. DIAGNOSTIC METHOD Judge as NG when the following conditions are established.
Time Needed for Diagnosis: 10 time(s) engine revs. Malfunction Indicator Light Illumination: Illuminates when malfunction occurs in 2 continuous driving cycles. |
Removal
1. Release the fuel pressure. Fuel > PROCEDURE2. Disconnect the ground terminal from battery sensor. NOTE3. Open the fuel filler lid and remove the fuel filler cap.NOTE:This operation is required to release the inner pressure of the fuel tank.4. Drain approximately 3.0 L (3.2 US qt, 2.6 Imp qt) of ...