Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc p0500 vehicle speed sensor "a" circuit

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc p0500 vehicle speed sensor "a" circuit

DTC DETECTING CONDITION:

Immediately at fault recognition

TROUBLE SYMPTOM:

VDC does not operate.

STEP	CHECK	YES	NO
1.CHECK DTC. Read the DTC of VDC system using the Subaru Select Monitor.	Is DTC displayed-	Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)	Repair the poor contact of connector and harness between VDCCM&H/U and wheel speed sensor.

1. OUTLINE OF DIAGNOSIS

• Judge the malfunction of VDC wheel speed sensor.

• Judge as NG when the wheel speed sensor normal status signal from VDC is cleared.

2. EXECUTION CONDITION

Secondary Parameters	Execution condition
12 V battery system voltage	≥ 10.9 V

3. DIAGNOSTIC METHOD

If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.

Judgment Value

Malfunction Criteria

Threshold Value

Signal of malfunction from Vehicle Dynamics Control Module

NOTE:

The VDC controller detects malfunction if one of the speed sensors does not output a signal and the other vehicle speed sensor output signal is above 7.46 MPH.

Time Needed for Diagnosis: 2.5 seconds

Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.

Dtc p0604 internal control module random access memory (ram) error

DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:TCM RAM malfunctionSTEPCHECKYESNO1.CHECK DTC.1) Perform the Clear Memory Mode using the Subaru Sel ...

Dtc u0140 lost communication with body control module

NOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedure. Basic Diagnostic Procedure1. OUTLINE OF DIAGNOSIS• Detect malfunction of CAN communication.• Judge as NG whe ...

Other materials:

Installation
1. Install the purge control solenoid valve, and connect the connector and vacuum hose to the purge control solenoid valve.NOTE:Connect the vacuum hose as shown in the figure.(a)To intake manifold(b)To fuel pipe Tightening torque:19 N·m (1.9 kgf-m, 14.0 ft-lb)2. Install the air intake boot. ...