Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc u0100 lost communication with ecm/pcm "a"

Subaru Legacy BN/BS (2015-2019) Service Manual / Eyesight (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc u0100 lost communication with ecm/pcm "a"

Detected when CAN data from engine control module (ECM) is not transmitted to stereo camera.

NOTE:

Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE

Dtc u0428 invalid data received from steering angle sensor module

Failure counter diagnosis of steering angle sensorNOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE ...

Dtc u0073 control module communication bus off

Detected when an error occurs in the CAN line. (Bus off)NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE ...

Other materials:

Inspection
1. CHECK ACCELERATOR PEDAL SENSOR AREA (METHOD WITH CIRCUIT TESTER)1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the ECM. Engine Control Module (ECM) > REMOVAL Engine Control Module (ECM) > REMOVAL3. Install the ST between the ECM and bulkhead harness and the engine harness ...