Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc u0402 invalid data received from tcm

DTC DETECTING CONDITION:

Received error data from TCM.

TROUBLE SYMPTOM:

SPORT indicator light blinks.

STEPCHECKYESNO

1.CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.

Was the basic diagnostic procedure performed up to STEP 8-

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0402 INVALID DATA RECEIVED FROM TCM

Perform the basic diagnostic procedure. Basic Diagnostic Procedure

2.CHECK DTC.

Check the displayed DTC.

Are DTCs other than U*** displayed-

Perform the diagnosis according to DTC.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0402 INVALID DATA RECEIVED FROM TCM

3.CHECK DTC.

Check the displayed DTC.

Is DTC for the bus off or the data no-receive displayed-

Perform the diagnosis according to DTC.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0402 INVALID DATA RECEIVED FROM TCM

4.CHECK DTC.

Check the displayed DTC.

Is U0402 a current malfunction-

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0402 INVALID DATA RECEIVED FROM TCM

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0402 INVALID DATA RECEIVED FROM TCM

5.CHECK DTC.

1) Turn the ignition switch to OFF.

2) Disconnect the TCM connector.

3) Connect the disconnected connectors.

4) Read the DTC using Subaru Select Monitor.

Is U0402 a current malfunction-

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0402 INVALID DATA RECEIVED FROM TCM

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0402 INVALID DATA RECEIVED FROM TCM

6.CHECK DTC.

Using the Subaru Select Monitor, read DTC of all the systems.

Is the transmission data abnormal detected in several modules-

Replace the TCM. Transmission Control Module (TCM)

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0402 INVALID DATA RECEIVED FROM TCM

7.REPLACE MODULE.

1) Replace the TCM.

2) Read the DTC using Subaru Select Monitor.

Is U0402 a current malfunction-

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0402 INVALID DATA RECEIVED FROM TCM

System is normal.

8.CHECK MODULE.

1) Reinstall the TCM.

2) Replace the module that the DTC has been detected.

3) Read the DTC using Subaru Select Monitor.

Is U0402 a current malfunction-

Replace the TCM. Transmission Control Module (TCM)

System is normal.

9.CHECK HARNESS.

1) Shake the harness, and check for poor contact.

2) Using the Subaru Select Monitor, read DTC of CAN system.

Is U0402 a current malfunction-

Repair the poor contact of harness, or replace the harness.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0402 INVALID DATA RECEIVED FROM TCM

10.CHECK CONNECTOR.

Check the connector used for high speed CAN for poor contact.

Is there poor contact of connector-

Repair the connector that has poor contact, or replace harness.

It is possible that temporary poor communication occurs. Delete the DTC.

Dtc u0416 invalid data received from vehicle dynamics control module
DTC DETECTING CONDITION:Data from VDCCM is faulty.TROUBLE SYMPTOM:ABS warning light and VDC warning light illuminate.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.Was the basic diagno ...

Dtc u0401 invalid data received from ecm/pcm "a"
DTC DETECTING CONDITION:Defective data from ECM.TROUBLE SYMPTOM:Defective data on CAN communication occurs.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.Was the basic diagnostic proce ...

Other materials:

Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the arm assembly - windshield wiper. Front Wiper Arm > REMOVAL3. Remove the cowl panel - side and the cowl panel assembly. Cowl Panel > REMOVALCAUTION:Before removing the cowl panel, use an air blower and nylon brush to sweep gr ...

© 2017-2024 Copyright www.sulegacy.com