Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: General diagnostic table inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Differentials / General diagnostic table inspection

Symptom or trouble

Possible cause

Remedy

1. Oil leakage

(1) Worn, scratched, or incorrectly seated front or side oil seal. Scored, battered or excessively worn sliding surface of companion flange.

Repair or replace.

(2) Clogged or damaged air breather cap.

Clean, repair or replace.

(3) Loose bolts on the side retainer, or incorrectly fitted O-ring.

Tighten the bolts to specified torque. Replace the O-ring.

(4) Loose rear cover attachment bolts or damaged gasket.

Replace the gasket, and tighten the bolts to specified torque.

(5) Loose filler plug or drain plug.

Apply liquid gasket, and tighten to the specified torque. (T-type)

Replace the gasket, and tighten to the specified torque. (VA-type)

(6) Wear, damage or incorrect fitting of drive shaft, side retainer or oil seal.

Repair or replace.

2. Seizure

NOTE:

Seized or damaged parts should be replaced, and also other parts should be thoroughly checked for any defect and should be repaired or replaced as required.

(1) Insufficient backlash for hypoid gear.

Readjust or replace.

(2) Excessive preload for side, rear or front bearing.

Readjust or replace.

(3) Insufficient or improper oil used.

Add recommended oil to the specified level.

3. Damage

NOTE:

Damaged parts should be replaced, and also other parts should be thoroughly checked for any defect and should be repaired or replaced as required.

(1) Improper backlash for hypoid gear.

Readjust or replace.

(2) Insufficient or excessive preload for side, rear or front bearing.

Readjust or replace.

(3) Excessive backlash for differential gear.

Replace gear or thrust washer.

(4) Loose bolts and nuts such as hypoid driven gear bolt.

Retighten.

(5) Damage due to overloading.

Replace.

4. Noises when starting or shifting gears

NOTE:

Noises may be caused by differential assembly, universal joint, wheel bearing, etc. Find out what is actually making noise before disassembling.

(1) Improper tooth contact of hypoid driven gear and drive pinion.

Readjust. (Drive pinion adjustment and backlash adjustment)

(2) Excessive backlash for hypoid driven gear.

Replace the gear or the pinion height adjusting washer.

(3) Excessive backlash for side gear.

Replace gear or thrust washer.

(4) Insufficient preload for front or rear bearing.

Readjust.

(5) Loose drive pinion nut.

Tighten to the specified torque.

(6) Loose bolts and nuts such as side retainer attachment bolt.

Tighten to the specified torque.

5. Noises when cornering

(1) Damaged differential gear.

Replace.

(2) Excessive wear or damage of thrust washer.

Replace.

(3) Broken pinion mate shaft.

Replace.

(4) Seized or damaged side bearing.

Replace.

6. Gear Noise

NOTE:

Since noises from engine, muffler, transmission, propeller shaft, wheel bearings, tires, and body are sometimes mistaken for noises from differential assembly, be careful in checking them. Inspection methods to locate noises include coasting, accelerating, cruising, and lifting-up all four wheels. Perform these inspections according to the condition of trouble. When listening to noises, shift the gear into four-wheel drive and fourth speed position, trying to pick up only differential noise.

(1) Improper tooth contact of hypoid driven gear and drive pinion.

Readjust or replace the hypoid gear set.

(2) Improper backlash of the hypoid driven gear.

Readjust.

(3) Scored or chipped teeth of hypoid gear.

Replace hypoid gear set.

(4) Scuffed hypoid gear.

Replace hypoid gear set.

(5) Improper preload for front or rear bearings.

Readjust.

(6) Stuck, scored or chipped teeth of front or rear bearing.

Replace.

(7) Stuck, scored or chipped teeth of side bearing.

Replace.

(8) Vibrating differential gear.

Replace the differential gear.

Front differential assembly note
1. CVT (TR580) MODELFor front differential for the CVT (TR580) model, refer to the “CVT (TR580)” section. Front Differential Assembly2. CVT (TR690) MODELFor front differential for the CVT ...

Differential gear oil
...

Other materials:

SRS seat cushion airbag operation
Driver's side  Passenger's side WARNING The SRS seat cushion airbag is designed not to deploy when the seatbelt for the corresponding seat is not fastened. For safety, all persons in the vehicle should fasten their seatbelts. The SRS seat cushion airba ...

© 2017-2024 Copyright www.sulegacy.com