Subaru Legacy BN/BS (2015-2019) Owners Manual: Headlight flasher

Subaru Legacy BN/BS (2015-2019) Owners Manual / Instruments and controls / Light control switch / Headlight flasher

Headlight flasher

CAUTION Do not hold the lever in the flashing position for more than just a few seconds.

To flash the headlights, pull the lever toward you and then release it. The high beam will stay on for as long as you hold the lever. The headlight flasher works even though the lighting switch is in the off position.

When the headlights are on high beam, the high beam indicator light " " on the combination meter also illuminates.

High/low beam change (dimmer)

To change from low beam to high beam, push the turn signal lever forward. When the headlights are on high beam, the high beam indicator light " " on the combination meter is also on. To ...

Daytime running light system

WARNING The brightness of the illumination of the high beam headlights is reduced by the daytime running light system. The light switch must always be turned to the " " position ...

Other materials:

Installation
1. SEDAN MODEL1. Install the light assembly - high-mounted.2. Install the trim panel assembly - rear shelf. Rear Shelf Trim > INSTALLATION3. Connect the ground terminal to battery sensor. NOTE2. OUTBACK MODELCAUTION:Make sure the bolt is tightened securely because improper roof spoiler installatio ...