1. INSPECT THE SPECIFIED POSITION 1. Measure the specified position of the stop light switch ends. Specified position L: 3.6 mm ±0.4 mm (0.14 in ±0.016 in) 2. Measure the clearance between the end of the stop light switch and the stopper. CAUTION: Be careful not to rotate the stop light switch. Stop light switch clearance A: 1.1 mm (0.03 — 0.04 in)
3. Adjust the position of the stop light switch if the inspection result is not within the standard value. Stop Light Switch > ADJUSTMENT 4. If the stop light switch does not operate properly or it is not secured at the specified position after adjustment, replace with a new part. 2. INSPECT THE RESISTANCE 1. Check the resistance between connector terminals. Preparation tool: Circuit tester
2. Replace the stop light switch if the inspection result is not within the standard value. |
Dtc b2a05 left speaker/audio circuit
DIAGNOSIS START CONDITION:When ACC is ON.DTC DETECTING CONDITION:Speaker impedance is more than 10 k- for 100 mS. (Detached speaker connection, etc.)TROUBLE SYMPTOM:• Call function cannot be used.• RED LED illuminates.WIRING DIAGRAM:NOTE:For the coupling connector, refer to “WIRING ...