1. CLUTCH DISC 1. Facing wear Measure the depth from the facing surface to the rivet head. Replace if the face is worn locally or worn down to less than the specified value. Depth to rivet head: Limit of sinking 0.8 mm (0.031 in) NOTE: Do not wash the clutch disc with any type of cleaning fluid. 2. Hardened facing Replace the clutch disc. 3. Oil soakage on facing Replace the clutch disc and inspect the transmission front oil seal, transmission case mating surface, engine rear oil seal and other locations for oil leakage.
4. Deflection on facing If deflection exceeds the specified value at the outer circumference of the facing, replace the clutch disc.
Limit for deflection: 0.7 mm (0.028 in) at R = 110 mm (4.33 in) 5. If there is spline wear, loose rivets, failed damper springs, etc., replace the clutch disc.
2. CLUTCH COVER NOTE: Visually check the following items without disassembling, and replace or repair if defective. 1. Loose thrust rivet 2. Damaged or worn bearing contact area at the center of diaphragm spring
3. Damaged and worn disc contact surface of the pressure plate 4. Loose strap plate installation area 5. Worn diaphragm sliding area
|
Inspection
1. YAW RATE & LONGITUDINAL G AND LATERAL G SENSOR SIGNALSTEPCHECKYESNO1.CHECK YAW RATE & G SENSOR.1) Check the installation condition of the VDC control module & hydraulic control module (VDCCM&H/U).2) Using the Subaru Select Monitor, display «Data monitor».3) Read the output of «Yaw Rate Sensor ...