1. CLUTCH START SWITCH 1. Perform the following inspections. If the clutch start switch does not operate normally, adjust the switch, and check it again. Clutch Switch > ADJUSTMENT • Make sure that engine does not start with clutch pedal not depressed. • Make sure that engine starts with clutch pedal fully depressed. 2. When the clutch start switch does not operate normally even if it is adjusted, check the clutch start switch for continuity. (1) Remove the clutch start switch. Clutch Switch > REMOVAL (2) Measure the resistance between terminal 1 and 2 of the switch. If the resistance is not at the standard value, replace the switch.
(3) Check that the switch is turned on and off in dimension L. Dimension L: 4 — 5.5 mm (0.16 — 0.22 in)
(4) Install the clutch start switch. Clutch Switch > INSTALLATION 2. CLUTCH SWITCH 1. Check the clutch switch for continuity. (1) Disconnect the connector of clutch switch. (2) Measure the resistance between terminal 1 and 2 of the switch. If the resistance is not within the specification, check the clutch stroke and installation condition, and check the clutch switch again.
2. When the clutch switch does not operate normally even if the clutch stroke and installation condition are normal, check the clutch switch for continuity. (1) Remove the clutch switches. Clutch Switch > REMOVAL (2) Measure the resistance between terminal 1 and 2 of the switch. If the resistance is not at the standard value, replace the switch.
(3) Check that the switch is turned on and off in dimension L. Dimension L: 5 — 6.5 mm (0.2 — 0.26 in)
(4) Install the clutch switch. Clutch Switch > INSTALLATION |
Dtc p0976 shift solenoid "b" control circuit low
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Gear is not changed. (No down-shift)1. ENGINE TYPE FBWIRING DIAGRAM:CVT control system CVT Control System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK HARNESS.CAUTION:Start work after ATF cools down.1) Turn the ignition switch to OFF. ...