Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr580) / Control valve body / Inspection

• Check each part for damage or dust.

• Measure the resistance of each solenoid, sensor and ground wire.

NOTE:

Measurement should be performed at a temperature of 20°C (68°F).

• Solenoid

Solenoid	Terminal No.	Standard
Primary UP solenoid	No. 2 — control valve body	Approx. 10 — 13.5 -
Secondary solenoid	No. 3 — control valve body	Approx. 5 — 7 -
F&R clutch solenoid	No. 4 — control valve body	Approx. 4 — 6 -
Primary DOWN solenoid	No. 7 — control valve body	Approx. 10 — 13.5 -
Lock-up duty solenoid	No. 9 — control valve body	Approx. 10 — 13.5 -
AWD solenoid	No. 10 — control valve body	Approx. 2 — 4.5 -

• Oil temperature sensor

Sensor

Terminal No.

Standard

At 20°C (68°F)

Oil temperature sensor

No. 1 — No. 6

Approx. 2.5 k-

• Transmission ground

Terminal No.	Standard
No. 8 — control valve body	Less than 1 -

Removal

CAUTION:• Directly after the vehicle has been running or the engine has been idling for a long time, the CVTF is hot. Be careful not to burn yourself.• Be careful not to spill CVTF on the ...

1. Clean the mating surface of valve cover and transmission side.CAUTION:When cleaning the mating surface of the transmission side, be careful not to allow any dust, foreign matter and used liquid gas ...

Other materials:

Dtc b16a7 short in front sub sensor lh (to ground)
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Shorted between front sub sensor LH circuit and GND circuitWIRING DIAGRAM:NOTE:For the coupling connector, refer to “WIRING SYSTEM”.Airbag system Airbag System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK POOR C ...

Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Removal

Installation

Other materials: