1. Remove the bulkhead harness connector from TCM. Transmission Control Module (TCM) > REMOVAL 2. Set the ST between the TCM and bulkhead harness.
3. Set the probe of oscilloscope to the check board connector. Terminals: No. 12 (+) — No. 26 (−)
4. Lift up the vehicle and raise the vehicle speed up to 20 km/h (12 MPH). 5. Check the waveform of front wheel speed sensor when vehicle speed is at 20 km/h (12 MPH). NOTE: The waveform cycle changes as the speed changes. |
Disassembly
1. Remove the boot and push rod.2. Apply compressed air through clutch hose attachment hole.NOTE:Face the piston hole down and place a piece of wood underneath to prevent the piston from popping out.3. Separate the piston and piston spring. ...