1. Remove the bulkhead harness connector from TCM. Transmission Control Module (TCM) > REMOVAL 2. Set the ST between the TCM and bulkhead harness.
3. Set the probe of oscilloscope to the check board connector. Terminals: No. 14 (+) — No. 42 (−)
4. Start and warm up the engine. 5. Check the waveform of primary speed sensor with engine idling. NOTE: The waveform cycle changes as the speed changes. |
Dtc b2271 ign relay control circuit
DTC DETECTING CONDITION:• When malfunction is detected in IG1 and IG2 drive circuits in the keyless access CM.• When malfunction is detected in IG hold circuit in the keyless access CM.TROUBLE SYMPTOM:Not all functions operate at IGN ON.CAUTION:For replacement procedure of keyless access ...