1. Remove the bulkhead harness connector from TCM. Transmission Control Module (TCM) > REMOVAL 2. Set the ST between the TCM and bulkhead harness.
3. Set the probe of oscilloscope to the check board connector. Terminals: No. 13 (+) — No. 26 (−)
4. Start and warm up the engine. 5. Check the waveform of secondary speed sensor with engine idling. NOTE: The waveform cycle changes as the speed changes. |
Component
1. REAR SUSPENSION(1)Rear sub frame ASSY(11)Support - sub frameTightening torque: N·m (kgf-m, ft-lb)(2)Rear sub frame stopper upper (sedan model)(12)Flange nutT1:33 (3.4, 24.3)(3)Rear sub frame stopper upper (OUTBACK model)(13)Rear stabilizerT2:38 (3.9 28.0)(4)Front sub frame support plate(14 ...