Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection
1. Visually check the harness and connector for damage or crack. 2. Check the harness terminal for rust, disconnection or poor contact. 3. Check the continuity between harness terminals and oil temperature sensor. NOTE: Refer to WIRING SECTION for transmission harness terminal and oil temperature sensor terminal. CVT Control System > WIRING DIAGRAM Harness continuity standard: Less than 1 - Oil temperature sensor standard: Approx. 2.6 k- (at 20°C) |
Removal
1. Remove the transmission from the vehicle. Automatic Transmission Assembly > REMOVAL2. Prepare for overhaul. Preparation for Overhaul3. Remove the transmission harness ground terminal and remove t ...
Installation
1. Install the harness clip to the transmission assembly.2. Insert the transmission harness bushing into the round hole on the transmission case and install the bolt.NOTE:• Use new O-rings.&bull ...
Other materials:
Installation
1. SEDAN MODEL1. Install the woofer assembly.Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-lb)2. Install the trim panel assembly - rear shelf. Rear Shelf Trim > INSTALLATION3. Connect the ground terminal to battery sensor. NOTE2. OUTBACK MODEL1. Install the woofer assembly.Tightening torque: ...
