Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr690) / X mode switch / Inspection

1. CHECK SWITCH UNIT

Measure the resistance between connector terminals of the X mode switch.

	Terminal No.	Standard
OFF (when measured without operating the switch)	No. 1 — No. 4	1 M- or more
ON (when measured with the switch held down)	No. 1 — No. 4	Less than 1 -

2. CHECK X MODE SYSTEM

Refer to “CVT (TR580)” section for X mode system inspection. X MODE Switch > INSPECTION

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the cover - shift lever. Console Box > REMOVAL3. Remove the X mode switch from the cover - shift lever. ...

Installation

1. Install X mode switch to the cover - shift lever.2. Install the cover - shift lever. Console Box > INSTALLATION3. Connect the ground terminal to battery sensor. NOTE ...

Other materials:

Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the overhead console. (Models without EyeSight) Spot Map Light > REMOVAL3. Remove the stereo camera cover assembly. (Models with EyeSight) Stereo Camera > REMOVAL4. Remove the motor assembly - sunroof.(1) Disconnect the harness ...