Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

1. Check that the engine coolant temperature sensor has no deformation, cracks or other damages.

2. Immerse the engine coolant temperature sensor and a thermometer in water.

CAUTION:

Take care not to allow water to get into the engine coolant temperature sensor connector. Completely remove any water inside.

(A)

Thermometer

(B)

Engine coolant temperature sensor

(C)

Hexagonal part height: To approx.1/3

3. Raise water temperature gradually, measure the resistance between the engine coolant temperature sensor terminals when the temperature is 20°C (68°F) and 80°C (176°F).

NOTE:

Agitate the water for even temperature distribution.

Water temperature

Terminal No.

Standard

20°C (68°F)

1 and 2

Approx. 2.45+0.14 −0.13 k-

80°C (176°F)

Approx. 0.318±0.008 k-

Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Drain engine coolant. Engine Coolant > REPLACEMENT3. Disconnect the connector (A) from the engine coolant temperature sensor, and remove ...

Installation
1. Install the engine coolant temperature sensor, and connect the connector to the engine coolant temperature sensor.NOTE:Use a new gasket.Tightening torque:18 N·m (1.8 kgf-m, 13.3 ft-lb)2. Con ...

Other materials:

Dtc u0422 invalid data received from body control module
NOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedure. Basic Diagnostic Procedure1. OUTLINE OF DIAGNOSIS• Detect malfunction of CAN communication.• Judge as NG when data received from the body integrated unit is not normal.2. EXECUTION CONDITIONSecondary Paramete ...

© 2017-2024 Copyright www.sulegacy.com