1. ACTUATOR LINK 1. Visually check the operating range of the link, and remove the foreign matter if any. 2. Operate the temperature control switch, and check that the link operates normally. 3. If it does not operate normally as the result of inspection, perform a unit inspection of motor - actuator mix. 2. CHECK ACTUATOR OPERATION 1. Check the actuator operation when battery voltage is applied between the connector terminals. CAUTION: Disconnect the battery immediately after the actuator stops operation. Otherwise, the motor may be damaged.
2. Measure the resistance between connector terminals. Preparation tool: Circuit tester
3. Connect the connector, turn the ignition switch to ON, and check the voltage between actuator terminals. • Driver’s seat
• Passenger’s seat
4. Replace the motor - actuator mix if it is found defective as a result of inspection. |
Inspection
1. Check the thickness of the pad - disc brake rear.NOTE:• Always replace the pads of both wheels and both sides as a set.• Replace pad clips if they are twisted or worn.• Replace the pad if there is oil or grease on it.• Wear indicators are installed on the pad - disc brake ...