Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Hvac system (heater ventilator and a c) / Blower resistor (manual a c model) / Inspection

1. Measure the resistance between connector terminals.

Preparation tool: Circuit tester

Terminal No.	Inspection conditions	Standard
4 — 2	Always	Approx. 0.44 -
4 — 3		Approx. 1.12 -
4 — 1		Approx. 2.92 -

2. Replace the blower resistor if the inspection result is not within the standard value.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Release the hook, and remove the under cover assembly - passenger.3. Remove the blower resistor.(1) Disconnect the connector.(2) Remove t ...

Installation

1. Install the blower resistor.2. Install the under cover assembly - passenger.3. Connect the ground terminal to battery sensor. NOTE ...

Other materials:

Installation
1. Replace the rear differential side oil seal. Rear Differential Side Oil Seal > REPLACEMENTNOTE:After pulling out the drive shaft assembly, be sure to replace with a new oil seal.2. Insert the drive shaft assembly into the rear hub spline, and pull it into the specified position.CAUTION:• B ...