1. ACTUATOR LINK 1. Visually check the operating range of the link, and remove the foreign matter if any. 2. Operate the FRESH/RECIRC switch, and check that the link operates normally. 3. If it does not operate normally as the result of inspection, perform a unit inspection of motor - actuator blower. 2. CHECK ACTUATOR 1. Check the actuator operation when battery voltage is applied between the connector terminals. CAUTION: Disconnect the battery immediately after the actuator stops operation. Otherwise, the motor may be damaged.
2. If it does not operate normally as the result of inspection, replace the motor - actuator blower. |
Inspection
(1)Ignition switch(7)VDC OFF indicator light(13)VDC warning light & VDC indicator light(2)OFF(8)Electronic parking brake warning light(14)2 seconds or more(3)ON(9)Hill hold indicator light(15)Electronic parking brake operation indicator light(4)Engine start(10)Light OFF(16)Parking brake(5)ABS warnin ...