Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Door switch / Inspection

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.

Inspection conditions

Standard

Front LH: 1 — 2

Except for front LH: 1 — 4

When the switch is not pressed

Less than 1 -

When the switch is pressed

1 M- or more

2. Replace the switch assembly - door if the inspection result is not within the standard value.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the switch assembly - door.(1) Remove the screws, and pull out the switch assembly - door toward you.(2) Disconnect the connector ...

Installation

1. Install the switch assembly - door.2. Connect the ground terminal to battery sensor. NOTE ...

Other materials:

Dtc b2285 steering lock position signal correlation
DTC DETECTING CONDITION:When the steering lock position signal transmitted from the steering lock CM via solid line and the steering lock position signal transmitted via LIN communication system do not match.TROUBLE SYMPTOM:• There are conditions when the steering lock is not released.• ...