Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Hazard switch / Inspection

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Standard
2 — 3	Switch OFF	1 M- or more
2 — 3	Switch ON	Less than 1 -

2. Apply battery voltage between the connector terminals to check the lighting condition of the light.

Terminal No.	Inspection conditions	Specification
4 (+) — 1 (−)	Apply battery voltage.	Light ON

3. Replace the switch - hazard if the inspection result is not within the standard value.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the center grille assembly. Air Vent Grille > REMOVAL3. Release the claws, and then remove the switch - hazard. ...

CAUTION:After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.1. Install the switch - hazard.2. Install ...

Other materials:

Installation
1. Set the range select lever to the “N” range.2. Install the parking pawl shaft, return spring and parking pawl.NOTE:Make sure that the end of return spring sticks out of parking pawl as shown in (a). Make sure that the other end contacts the rib of intermediate case as shown in (b).(A) ...